0.1 ㎡ single-stage molecular distillation experimental device

Remove the binding materials of each part, and clean the inside of the oil pipe with clean kerosene, especially the thread of the connection port of each oil pipe.

Category

Special equipment for laboratory

Keywords

sgq@tjyghl.cn

Inquiry

Details

Connection of hydraulic system
(1) Remove the binding materials of each part, and clean the inside of the oil pipe with clean kerosene, especially the thread of the connection port of each oil pipe.
(2) Check whether the gasket at the joint is complete. If it is damaged due to transportation, take a new gasket attached to the testing machine and install it to prevent oil leakage under high pressure.
(3) Use a suitable wrench to connect each oil pipe. If it is a seamless copper pipe, it should be connected to the host, and the spacing should be adjusted depending on the movement of the console to connect the control console.
(4) Drain the residual oil in the oil tank and remove the residues in the oil tank.
(5) Open the iron door of the hydraulic control box, you can see the wire mesh oil filter, which will be injected into the oil tank when filling oil. The testing machine usually uses hydraulic oil. In summer, hydraulic oil with higher viscosity should be used, and in winter, hydraulic oil with lower viscosity should be used.
(6) Pay close attention to the oil level when refueling. The tester cannot work normally if the oil quantity is too small, and too much oil will cause hydraulic oil to leak from the working cylinder port.

0.1 ㎡ two-stage molecular distillation test device

0.1 ㎡ single-stage molecular distillation experimental device

0.1 ㎡ two-stage molecular distillation test device

0.1 ㎡ single-stage molecular distillation experimental device

Releated Product